We needed to compensate eleven hours from the past week, so the estimated hours were in fact 65.5 (54.5 + 11). We did some tasks in less time than expected and did a task in advance and now we are ON TIME.
| Team Member | Worked Hours | Estimated Hours |
|---|---|---|
| Arthur | 12.9 | 11 |
| Diogo | 14.9 | 11.6 |
| Lucas | 13.4 | 10.8 |
| Matheus | 13.7 | 10.9 |
| Victor | 9.8 | 10.2 |
| Total | 64.7 |
The structure was made using polystyrene (PS) and is shown in the following pictures:
Figure 1 - Right side of the structure.
Figure 1 - Right side of the structure.
Figure 2 - Left side of the structure.
Figure 2 - Left side of the structure.
Figure 3 - Back side of the structure.
Figure 3 - Back side of the structure.
Figure 4 - Front side of the structure.
The keys and the key stand were 3D printed using PLA, the 0-9 keys and the key stand were printed using black filament, while the “BRANCO”, “CORRIGE” and “CONFIRMA” keys used white filament, the “CORRIGE” key was painted orange and the “CONFIRMA” key was painted green. All the keys have been finely detailed to highlight alphanumeric and braille characters.
Below are some pictures of before and after painting the keys.
Figure 5 - General view of the keys and the key stand before painting.
Figure 6 - Detailed view of the keys before painting.
Figure 7 - General view of the keys and the key stand after painting.
Figure 8 - Detailed view of the keys after painting.